Soudal 410ml / 300ml Soudafix Polyester (Styrene) Chemical Resin - P300-ST

Soudal Soudafix P300-SF Chemical Anchor Set Styrene Free Low Odour Resin

Soudal Soudafix P300-SF 410ml must be used with Chemical Anchor Gun

Soudafix P300-SF is a polyester resin based chemical anchor that's ideal for anchoring of threaded rods and chemical anchors in solid uncracked concrete.

Styrene free, low odour suitable for internal and external use.

M8 to M16 for heavy loads and masonry 18 brick types anchoring.

Soudafix P300 is a 2 part SF styrene free rapid curing chemical resin anchoring system housed in cartridge.

Designed for fixing of railings, satellite dishes, signs, brackets and other fixtures which carry heavy loads fixing down machinery etc.

The unique easy dispense technology of Soudafix Anchor Fix has the twin bag system within the cartridge enables the product to be mixed at the nozzle.

Benefits

Easy mix twin bag system

410ml needs to be applied with the soudal Soudafix Chemical Anchor Gun

Securing of heavy loads in solid and hollow building materials

Rapid curing system

Super strong

High chemical resistance

High water resistance

Pressure free anchoring even close to edges

Areas For Use

Fixing wall ties

Bolts and screws into a wide range of building substrates

Securing machinery into floors

Fixing studs and fixings

Threaded bar and chemical anchor fixings

Can also be used as a repair mortar

How to use P300-SF

Solid

Drill hole at recommended depth

Clean the hole with a air pump then with a brush and again with air thoroughly.

Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.

Dispense the chemical anchor into the hole from the bottom with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Hollow Brick or block

Drill hole at recommended depth

Clean the hole with a air pump then with a brush and again with air thoroughly.

Screw static mixer onto cartridge and dispense the first 10cm of the product to waste until an even colour dark grey is achieved with no light streaks.

Insert the sleeve dispense the chemical anchor insert and fill it bottom up so that the resin is pressed through the tiny holes of the sleeve with the long nozzle working upwards, there needs to be enough product in the hole that the chemical anchor spills over when the rod or anchor is pushed into the mix using a slight backwards and forwards screwing motion, this ensures that no water will sit in the hole and damaging the fixing over time.

Don’t move the anchor during curing

Once fully cured install component, applying the right torque

Installation parameters can be found int the technical data sheet

Refer to technical data sheet for instructions prior to commencing work.